The Rohde & Schwarz NRV-Z2 is a 50 Ohm, 500 mW, 10 MHz to 18 GHz Medium Sensitivity Diode Power Sensor.

The NRV-Z Series of high-sensitivity power sensors based on zero-bias Schottky diodes open up the power range below 1μW down to the physical limit of 100 pW (−70 dBm).

The post Rohde & Schwarz NRV-Z2 828.3218.03 Diode Power Sensor 50 Ohms 10 MHz to 18 GHz, 20 nW to 500 mW appeared first on Global Test Equipment.

The Anritsu MA2475A High Accuracy Power Sensor contains an additional matching circuit to improve return loss performance. They are used with the ML2430A Series Power Meters (sold separately). 10 MHz to 50 GHz range N, K, and V type RF connectors 90 dB dynamic range provides stable power readings to -70 dBm

The post Anritsu MA2475A Power Sensor, 10 MHz to 50 GHz appeared first on Global Test Equipment.

Frequency range of 50 MHz to 18 GHz

• Wide dynamic range of -30 to +20 dBm (peak/gated), -45 dBm to +20 dBm (average only mode)
• 30 MHz video bandwidth and single shot real-time capture at 80 Msample/sec per second
• Internal zeroing & calibration
• High measurement speed of up to 25,000 readings/second (free run/fast buffer mode)

The post Keysight U2021XA 50 MHz to 18 GHz USB Peak Power Sensor appeared first on Global Test Equipment.

The post Keysight 08498-60010 Attenuator Assembly 30dB appeared first on Global Test Equipment.

Global Test Equipment

The post Boonton 4210-4A Power Sensor appeared first on Global Test Equipment.

The post Boonton 41-4E Power Sensor, 200 kHz to 18 GHz, -60 to +10 dB, 1nW to 20 mW appeared first on Global Test Equipment.

The post Gigatronics 80330A 0.01 – 18 GHz Power Sensor appeared first on Global Test Equipment.

The post R&S NRV-Z6 Diode Power Sensor appeared first on Global Test Equipment.

The post Rohde & Schwarz NRP-Z57 Sensor, DC to 67 GHz, -35 dBm to +20 dBm, 1.85 mm Connector appeared first on Global Test Equipment.

10 Ft. Cord

The N192XA sensors are the first to provide internal zero and calibration by integrating a DC reference source and switching circuits into the power sensor. This feature eliminates the multiple connections associated with using an external calibration source, thus minimizing connector wear, test-time and measurement uncertainty.

Zero and calibrate while connected to the DUT
-35 dBm to +20 dBm wide dynamic range for peak power measurements
Calibration factors, linearity, temperature and bandwidth correction data stored in EEPROM
Precision 2.4mm connector as standard
Sensor cable fixed to sensor. Available cable lengths are 1.5m (5ft), 3m (10ft) and 10m (31ft)

The post Keysight N1922A P-Series Wideband Power Sensor, 50 MHz to 40 GHz, Option 105 appeared first on Global Test Equipment.